how to clean irobot roomba

Despite the fact that the Roomba will clean your floors for you, it won’t spotless itself a while later. So as to keep your Roomba running getting it done and keeping your floors their cleanest you will need to do a touch of support on it once in a while. I’d suggest cleaning the dust channel in it after consistently or third full cleaning cycle. This is a simple undertaking however getting the little tidy channel looking fresh out of the plastic new can be somewhat troublesome in the event that you don’t have the foggiest idea about the secret to doing it. Through a tiny bit of creativity and a touch of fortunes I found the trap.

images (2)


Before cleaning the dust channel we should do a normal post-clean cleaning of the Roomba. Take after these progressions to get your Roomba good to go:

Flip the Roomba over and haul out it’s molecule receptacle while holding it over your trash can

Precisely shake out it’s substance into the trash can

Open up the base area of the molecule receptacle and vacant it’s substance into the garbage can also

Painstakingly pop out the dust channel and put it aside

Complete the process of clearing out the molecule canister and put it aside without the dust channel introduced

Expel the brush deck module and clean the blender brush and in addition the abound brush

Brush the abound brush with the Roomba cleaning instrument (if essential)

Reassemble the brush deck module after it is free of all trash and reinsert into the Roomba

Embed molecule canister (without the air channel) into the Roomba and put the unit aside

Cleaning the Air Filter

Since you have cleaned whatever remains of the Roomba to working request we’ll give the air channel a decent cleaning since it won’t perform it’s best generally.

Run the high temp water on your spigot until it is busy’s most sizzling

Expel any overwhelming flotsam and jetsam you can with your fingers and place into the refuse

Hold the channel with it’s dirtiest side down under the boiling hot water gradually moving it forward and backward

After most of the channel is cleaned rub it with your fingers to get whatever is left of the earth out

Turn off the water and rest the channel over a fan or something else that will give it great wind current

Let dry for two or three hours

Assembling everything Back

Once your air channel has dried we can return it in.

Expel molecule pin from the Roomba

Open the base compartment and re-embed the channel

Close the base compartment and re-embed it once again into the Roomba

Place Roomba back on it’s charger or fitting it in

Your Roomba is currently good to go at the end of the day!